Date: Sat, 19 Mar 2005 21:57:30 -0800 (PST) From: Gregory Ballora <gregballora-AT-sbcglobal.net> Subject: Re: [Puptcrit] Puppet Eyes To: puptcrit-driftline.org-AT-lists.driftline.org Hey Steve, and all others, What kind of Vacuum Former do you have or use? What can you reccommend? --- Cahebay-AT-aol.com wrote: > > In a message dated 3/19/2005 10:17:42 P.M. Eastern > Standard Time, > steve-AT-axtell.com writes: > > Yes that works good or you can use air pressure to > blow heated styrene > through a hole in plywood making a free form dome. > > Or get a vacuum former! > > Ax > > > > Concerning the use of wood balls as Mr. Gamble > stated, It just popped into my > mind that one can go to the hardware store and > pick up several sizes of > wood > ball cabinet knobs with threaded bolts installed, > Obtaining several of > theses you > would also purchase a hand full of nuts to fit > and a scarp piece of 1/4 > inch plywood > place 2 nuts on the bolt and thread the bolt > through a hole drilled into > the plywood and > then place another nut on and tighten,(a washer > would be advised as well) > this is done with each wood ball cabinet knob. > what this will do is raise the wood knob off the > surface for working so > one can form > the styrene over the balls to create the eyes > Regards, > Mark > _cahebay-AT-aol.com_ (mailto:cahebay-AT-aol.com) > _______________________________________________ > List address: puptcrit-AT-lists.driftline.org > Admin interface: > http://lists.driftline.org/listinfo.cgi/puptcrit-driftline.org > Archives: http://www.driftline.org > _______________________________________________ List address: puptcrit-AT-lists.driftline.org Admin interface: http://lists.driftline.org/listinfo.cgi/puptcrit-driftline.org Archives: http://www.driftline.org
Display software: ArchTracker © Malgosia Askanas, 2000-2005