From: Cahebay-AT-aol.com Date: Fri, 3 Feb 2006 13:38:21 EST To: puptcrit-AT-lists.driftline.org Subject: Re: [Puptcrit] foam core In a message dated 2/3/2006 1:08:17 P.M. Eastern Standard Time, gretchen-AT-dramaofworks.com writes: --- Susan Wall Kronenberg <susan-AT-carouselpuppets.com> wrote: > Anyone have any good gadgets for cutting curves into foam > core? I'm > using a razor blade right now, and it's a real pain. I can't > push it > hard enough to go through all the layers at one time, so it's > hard to > do a clean cut. Any ideas? > > Susan To cut curves, not only as someone had stated about using a new blade one should be used with each new project, but I use a swivel knife which moves with the curves providing neat and clean cuts Regards Mark _ChristianPuppeteer and Clowns-* Christian Puppeteers and clown International Group_ (http://groups.yahoo.com/group/ChristianPuppeteer/) _______________________________________________ List address: puptcrit-AT-lists.driftline.org Admin interface: http://lists.driftline.org/listinfo.cgi/puptcrit-driftline.org Archives: http://www.driftline.org
Display software: ArchTracker © Malgosia Askanas, 2000-2005