File puptcrit/puptcrit.0602, message 121


From: Angusson-AT-aol.com
Date: Mon, 13 Feb 2006 18:34:14 EST
To: puptcrit-AT-lists.driftline.org
Subject: Re: [Puptcrit] another rod puppet - teddy bear


Thanks, Daniel:

I have been asked to make a custom marionette 24". 
The head is smaller than I am currently used to making. So I thought I'd go 
back to   my 'old' ways of many years ago and sculpt the head in plasticene, 
cast it in plaster and finish it up as I am used to.

So my question is: Can one cast Aves Epoxy   Sculpt into a plaster mold? If 
so, what does one use as a release agent, and where might one find this 
material.....?

I am grateful for your response and for the information.
Thanks and Best,
Fred


> Have you tried Aves Apoxie Sculpt? Fully carveable, drillable...very
> strong.......
> Had to run a festival workshop recently on puppet making and Apoxie sculpt
> wasnt available so grabbed Magic Sculpt instead....no one mentioned the six
> hour setting time!!!! Bit disconcerting when you expect a 30-40 minute
> setting time.......The joys eh?
> 
> Daniel
> 
> 

_______________________________________________
List address: puptcrit-AT-lists.driftline.org
Admin interface: http://lists.driftline.org/listinfo.cgi/puptcrit-driftline.org
Archives: http://www.driftline.org

   

Driftline Main Page

 

Display software: ArchTracker © Malgosia Askanas, 2000-2005