From: Christopher Hudert <heyhoot-AT-mindspring.com> Date: Sat, 24 May 2008 21:04:14 -0400 To: puptcrit-AT-puptcrit.org Subject: Re: [Puptcrit] connecting rod photos On May 24, 2008, at 5:00 PM, Gregory Ballora wrote: > So the carb clip is not attached to the puppet or to the rod, is that > correct? Well, not permanently to either. First you slide it up over the loop, so the two holes of the clip are on either side of the loop in the hand. Next, you put the bend of the rod thru the loop and holes of the clip. Then snap the lower part over the rod. Take it off in the reverse order. > Seems like an interesting solution, but a bit visible on the top of > the rod. Not really that visible as the tone is towards black for most of the metal clips, and it stays snug to the rod. Plus that is not usually where the audience's attention is on the puppet. > I am going to have to get a few of these to monkey around with. Take a piece of the rod you intend to work with if you can, so that you can get the appropriate size. Christopher _______________________________________________ List address: puptcrit-AT-puptcrit.org Admin interface: http://lists.puptcrit.org/mailman/listinfo/puptcrit Archives: http://www.driftline.org
Display software: ArchTracker © Malgosia Askanas, 2000-2005